Binzel BRS-FP Instructivo De Servicio página 43

BRS-FP
11 Disassembly
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance, servicing, assembly,
disassembly and repair work:
• Switch off the power source.
• Close the gas supply.
• Close the compressed air supply.
• Disconnect the power supply.
• Switch off the entire welding system.
NOTICE
• Disassembly must only be carried out by qualified personnel (in Germany, see TRBS 1203).
• Observe the information provided in the following section:
 8 Putting out of operation on page EN-19.
1 Unscrew the screws and remove the cleaning unit and the collecting tray.
2 Unscrew the screws and remove the support from the base.
12 Disposal
To correctly dispose of the product, it must first be disassembled. When disposing of the system, local
regulations, laws, provisions, standards and guidelines must be observed.
 11 Disassembly on page EN-21
12.1 Materials
This product is mainly made of metallic materials, which can be melted in steel and iron works and are thus
almost infinitely recyclable. The plastic materials used are labelled in preparation for their sorting and
separation for later recycling.
12.2 Consumables
Oil, greases and cleaning agents must not contaminate the ground or enter the sewage system. These
substances must be stored, transported and disposed of in suitable containers. Please observe the relevant
local regulations and disposal instructions in the safety data sheets specified by the manufacturer of the
consumables. Contaminated cleaning tools
(brushes, rags, etc.) must also be disposed of in accordance with the information provided by the
consumables' manufacturer.
12.3 Packaging
ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability to recycle
packaging materials is always considered during their selection.
DANGER
11 Disassembly
EN - 21