Maintenance And Cleaning - Binzel BRS-FP Instructivo De Servicio

BRS-FP
7 Operation
NOTICE
• As the BRS-FP torch cleaning station is integrated into a welding system, the operating instructions of
1 Switch on the robot control system.
2 Start the welding process.
3 Stop the welding process.
8 Putting out of operation
NOTICE
• As the BRS-FP torch cleaning station is integrated into a welding system, the process for putting it out
1 Switch off the robot control.

9 Maintenance and cleaning

Scheduled maintenance and cleaning are prerequisites for a long service life and trouble-free operation.
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance, servicing, assembly,
disassembly and repair work:
• Switch off the power source.
• Close the compressed air supply.
• Disconnect the power supply.
• Switch off the entire welding system.
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
NOTICE
• Maintenance and cleaning work may only be carried out by qualified personnel (in Germany see
• Always wear your personal protective equipment when performing maintenance and cleaning work.
the welding components, such as welding torch and robot control system, must be observed during
operation.
of operation depends on the robot control system. Please make sure that the shutdown procedures for
all components integrated in the welding system are strictly observed.
DANGER
DANGER
TRBS 1203).
7 Operation
EN - 19