Setting Up Easymp.net; Setting The Date And Time - Epson EMP-8300 EasyMP.net Guia De Instalacion

Setting up EasyMP.net

EasyMP.net will be available once the system date and time and the network
parameters have been set by means of EasyConfiguration.
The following section explains the standard system setup using the remote control
unit supplied with the projector. Also, the mouse and keyboard keys can be used for
easier operation.
Instructions on the operation of the remote control, mouse and keyboard (
Do not unplug the power cable when EasyMP.net is running (especially
when the screen is switched on or data is being read from the memory
card).
If you do, the system hardware may fail and the EasyMP.net screen may
not appear.

Setting the Date and Time

When the projector is turned on, the following screen appears.
EasyMP.net will be ready for use approximately 1 minute and 30
seconds after the projector is turned on.
PROCEDURE
1
Move the mouse pointer (
button on the remote control.
The Task Manager (
) to the bottom of the screen using the
p.34) will appear.
p.30)
15