Conditions For Use - LEGRAND Whad 0.8 kVA Manual Del Usuario

2 Conditions for use

• The UPS was designed to supply power to appliances for data elaboration; the load applied
must not exceed that stipulated on the label located on the rear of the UPS.
• The ON/OFF button of the UPS does not electrically insulate its internal parts. To insulate the
UPS, disconnect it from the mains power outlet.
• Do not open the UPS case since there may be energised parts inside, it that are dangerous even
when the UPS is not connected to the mains power outlet. In any case, there are no parts inside
the UPS that can be repaired by the consumer.
• The front control panel is for manual operation: do not use sharp or pointed objects.
• The UPS was designed to operate in a clean, closed environment that does not contain inflam-
mable liquids and corrosive substances and is not excessively damp.
Key
1. ON / OFF button
2. Functioning status indicator (green, yellow, red)
3. Input/output plug-socket
4. Rs232 computer interface socket
5. Connector for installation of additional battery units (optional)
6. Resettable circuit breaker
Whad 0.8, 1, 1.5 kVA
19