Controls & Features; Ignition Switch Module - Cub Cadet Z-Force S 48 Manual Del Operador

Controls and Features
Fuel Tank Cap
Choke Control
Throttle Control
NOTE: References to LEFT, RIGHT, FRONT, and REAR indicate that
position on the tractor when facing forward while seated in the
operator's seat.
Deck Lift Pedal
The deck lift pedal is located near the front of the tractor on the
left of the foot platform and is used to raise and lower the mower
deck. The deck lift pedal has 17 positions including the transport
position.
Push the pedal forward and rock back to lock into the transport
position, locking behind the notch on the front of the index
plate. Remove and replace the lock pin into the desired height
index hole, then push pedal forward and rock forward to unlock
and slowly allow the pedal to move back until it reaches the lock
pin.
Seat Adjustment Lever
Figure 4-1

Ignition Switch Module

To start the engine, insert the key
into the ignition switch and turn
clockwise to the START position.
Release the key into the NORMAL MOWING MODE position once
the engine has fired.
To stop the engine, turn the ignition key counterclockwise to the
STOP position.
Parking Break
Engagement Lever
Index Plate
Deck Lift Pedal
Drive Pedal
Reverse Pedal
WARNING!
Never
leave a running
machine unattended.
Always disengage
PTO, set parking
brake, stop engine
and remove key to
prevent unintended
starting.
CAUTION:
Prior to operating the tractor, refer to
both Safety Interlock Switches and Starting The
Engine in the Operation section of this manual for
detailed instructions regarding the Ignition Switch
Module and operating the tractor in REVERSE
CAUTION MODE.
4
Ignition
Switch
Module
Hour Meter/
Indicator Panel
PTO Switch
11