Controls & Features; Battery Level Indicator - Cub Cadet 188 Manual Del Operador

Controls and Features
Charge
Connector
Motor/Blade Control Handle
WARNING:
The motor / blade control handle is a
safety device. Never attempt to bypass its
operations.
The motor/blade control handle is located on the upper handle
of the mower. See Fig. 4-1. The motor/blade control handle
engages and disengages the motor and blade. The motor blade
control consists of three parts - starter button, motor/blade
control handle, and key.
Release the motor/blade control handle to stop the motor and
blade. Remove the key to prevent accidental starting when
equipment is unattended.
WARNING:
The blade will be rotating whenever
the motor is running.
Cutting Height Adjustment Lever
The cutting height adjustment lever is located above the left
rear wheel. To adjust the cutting height, refer to the Assembly &
Set-Up Section.
Motor/Blade Control Handle
Starter Button
Overload Protection Switch
Key
Cutting Height
Adjustment Lever
Figure 4-1

Battery Level Indicator

The battery level indicator is located on the motor cover. The
indicator shows the condition of the battery and is on when the
motor is on. The indicator lit all the way to the right indicates the
battery is fully charged; as the indicator is lit more toward the
left, it indicates the battery is discharging. See Fig. 4-1 inset.
IMPORTANT: If the far left red light illuminates, the batteries will
need to be recharged before further use. Continued operation
before charging may shorten the life of the batteries.
Overload Protection Switch
The mower is equipped with a overload protection switch,
located on the motor/blade control. This overload protection
switch may pop out when too much strain is placed on the
motor. Refer to Maintenance & Adjustments Section to reset this
switch.
Key
The key must be present and inserted before the motor can be
started.
Battery Level Indicator
4
11