C7115 Remote Control - ConMed Linvatec 10k Manual De Instrucciones

E
1.5.3

C7115 Remote Control

The Hand Held Remote Control allows the
operator full functionality of the 10k Pump from
within the sterile field.
❶
Flow Buttons — Press either of these
buttons to toggle between the preset High
(2000 ml/min.) and Low (1000 ml/min.)
flow rates. Note: These buttons have no
functionality when the Model 10k200
Laparoscopic Tubing Set is in use.
❷
Tamponade Assist Button — When the
pump is running, press this button for a
20 mmHg increase in set pressure. After
two minutes, set pressure automatically
returns to the original set point. Each
consecutive press of the button results in
another 20 mmHG increase. Pressing any
❶
❷
❸
❸
❹
❺
E-6
❶
❹
❺
other button returns the pump to the
original set point. Note: This button has
no functionality when the Model 10k200
Laparoscopic Tubing Set is in use.
Pressure Decrease Button — Press to
decrease set pressure.
Pressure Increase Button — Press to
increase set pressure.
"Run/Stop" Button — Press to start the
pump roller when the Standby switch is in
the on position. Press again to stop the
pump roller.