2.0
SYSTEM INSTALLATION
and OPERATION
2.1
Cart Installation
1.
To install the pump into a cart, perform
the following (the pump mounting kit,
Catalog number 10k009, is recommended
for mounting the pump to a flat surface):
(a) Wipe the contact areas of the cart shelf
and the underside of the pump with
alcohol wipes.
(b) Remove the protective liner from one
side of the DUAL-LOCK fastener and
adhere to the bottom of the pump, as
shown. Apply firm, uniform pressure to
ensure contact with the pump surface.
Repeat with second fastener.
(c) Press each mating piece of the DUAL-
LOCK fasteners to the previously
mounted strips on the bottom of the
pump.
(d) Remove the protective liner from each
piece and position the pump into its
desired position on the cart. Apply
firm, uniform pressure to the pump to
ensure good adhesive contact with the
cart surface.
NOTE:
After installation of the DUAL-
LOCK fasteners and pump, do not remove
from cart for 72 hours for maximum bond
strength.
2. The pump may be removed by lifting from
front to back.
E-7
E