GENERAL REMARKS ON THE CONSIGNMENT
SAFETY REGULATIONS
The present manual is an integral and
essential part of the product and will have to be
handed over to the user. Read carefully the
written warnings in the present manual as they
give important suggestions concerning the safety
of installation and set-up, use and maintenance.
Keep this manual in a safe place for further
information.
After removing the packaging, check the
integral parts of the machine are intact. If in
doubt, do not use the machine and contact the
professionally
qualified
elements of the packaging must be kept out of
children's reach as they can be potential
18
sources of danger and they mustn't be
disposed of in the environment.
m
POLLUTION DANGER
Before connecting the machine, make sure
that the data of the plate correspond to those of
the electrical distribution network. The plate is
located under the machine's base. The
installation has to be carried out in compliance
with the regulations of the Country where the
machine is set-up, according to the instructions
by the manufacturer and qualified personnel.
The
manufacturer
responsible for possible damage caused by
personnel.
The
failure in earthing the plant. For the electrical
safety of this machine it is obligatory to arrange
the earthing plant, contact an electrician with
proper and certified technical suitability, to check
the electrical capacity of the plant is adequate to
the maximum power of the machine, stated on
the plate. In particular the electrician will have to
make sure that the section of the plants' cables is
suitable to the power absorbed by the machine.
The use of adaptors, multi-sockets and
extensions is forbidden. If their use is necessary,
it is compulsory to call a licensed electrician.
The machine must be set-up according to the
sanitary and health regulations valid for hydraulic
can't
be
considered
plants. For the hydraulic plant contact an
authorised technician.