Victoria Arduino VENUS CENTURY Manual Técnico De Empleo página 30

HOW TO PROGRAMME THE DOSES
To open the dose programming function for
each of the groups, press and hold down key 5
for 5 seconds.
GROUP BUTTON PAD
1 2
Access to the programming mode is signalled
by the 5 buttons, which will begin to flash.
Press any of the dose keys to start delivery from
the group; once the required amount has been
poured, press key 5
store the dose in the memory. After the dose
has been stored, the relevant key will switch off
while the others will continue to flash. It is
now possible to proceed to set another dose or
to exit the programming function by pressing
26
key 5
of the groups, with the sole limit that only one
group can be programmed at a time; the other
groups will continue to operate as normal.
CUP REST HEIGHT ADJUSTMENT
It is possible to adjust the height of the cup
rests so that different-sized cups can be used
3 4 5 by proceeding as follows:
1
2
to stop delivery and
3
. This procedure is the same for each
Release the lock nut 1 in fig. 1.
Tighten/loosen the cup rest 2 in fig. 1 by
turning it anticlockwise/clockwise to
increase or reduce its height to the requi-
red level.
Tighten the lock nut 1 in fig. 1.
2
1
fig.1