Transport And Handling - Victoria Arduino VENUS CENTURY Manual Técnico De Empleo

TRANSPORT AND HANDLING

Always quote the machine serial number in all
communications to the manifacturer, Victoria
Arduino.
When contacting the manufacturer, Victoria
Arduino for any reason, always quote the
machine serial number.
The machine is transported on pallets contai-
ning several machines inside boxes secured to
the pallet by straps.
Before performing any transport or handling
operation, the operator must:
• wear safety gloves and footwear and overal-
ls with elasticised ends.
Pallets must be transported using an adequate
lifting mechanism (fork-lift truck type).
22
m
:
CAUTION COLLISION OR CRUSHING HAZARD
During the entire handling operation, the opera-
tor must make sure no one or nothing is inside
the operating area.
Slowly lift the pallet to about 30 cm from the
ground and move to the loading area. After
making sure there are no obstacles, persons or
things, proceed with loading.
Once at destination, always using an adequate
lifting mechanism (eg. fork-lift), after making
sure there is no one or nothing within the unloa-
ding area, lower the pallet to about 30 cm from
the ground and transport it to the storage area.
m
:
CAUTION COLLISION OR CRUSHING HAZARD
Before performing the following operation,
make sure the load is in place and is not likely
to fall when the straps are cut.
The operator, wearing safety gloves and
footwear, must now cut the straps and store
the product. To perform this operation, check
the technical characteristics of the product to
determine the weight of the machine to be
stored and take consequent precautions.
m
:
CAUTION POLLUTION HAZARD
Once the machine has been freed of the pallet
or container, do not discard these in the envi-
ronment - pollution hazard.