Manufacturer's Warranty; Originele Handleiding; Informatie Over Documentatie; Over Deze Documentatie - Hilti DSH 700 Serie Manual Del Usuario

Trouble or fault
Low engine power / poor
cutting performance
Cut-off wheel rotates while
the engine is idling.
Cut-off wheel doesn't rotate.
Starter assembly doesn't
work.
10 Disposal
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative for further information.
Drilling slurry
Disposal of drilling slurry directly into rivers, lakes or the sewerage system without suitable pretreatment
presents environmental problems.
▶ Ask the local public authorities for information about current regulations.
We recommend the following pretreatment:
▶ Collect the drilling slurry (for example, using a wet-type vacuum cleaner).
▶ Allow the drilling slurry to settle and dispose of the solid material at a construction waste disposal site
(addition of a flocculent may accelerate the settling process).
▶ The remaining water (alkaline, pH value greater than 7) must be neutralized by the addition of an acidic
neutralizing agent or diluted with a large volume of water before it is allowed to flow into the sewerage
system.
11 RoHS (Restriction of Hazardous Substances)
Click on the links to go to the table of hazardous substances: (DSH 700-X), qr.hilti.com/r11460300 and
(DSH 900-X) qr.hilti.com/r1160423.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
12

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.

Originele handleiding

1

Informatie over documentatie

1.1

Over deze documentatie

• Lees voor ingebruikname deze documentatie door. Dit is vereist voor veilig werken en storingsvrij gebruik.
• De veiligheidsinstructies en waarschuwingsaanwijzingen in deze documentatie en op het product in acht
nemen.
• De handleiding altijd bij het apparaat bewaren en het product alleen met deze handleiding aan andere
personen doorgeven.
40 Nederlands
Possible cause
The product is used at an altitude
greater than 1500 meters above
sea level.
Incorrect carburetor setting (fuel /
air mixture).
Idling speed is too high.
The half-throttle position is en-
gaged.
Faulty centrifugal clutch.
Inadequate drive belt tension or the
drive belt is broken.
The clutch claws are not engaging.
Starter cord is broken.
Action to be taken
▶ Have the carburetor adjusted
by Hilti Service.
▶ Have the carburetor adjusted
by Hilti Service.
▶ Check the idling speed and
adjust it if necessary.
▶ Release the half-throttle posi-
tion.
▶ Change the centrifugal clutch.
▶ Have the product repaired by
Hilti Service.
▶ Clean the clutch claws so that
they move freely.
▶ Replace the starter cord.
2122988
*2122988*