Emerson HF1160BQ02 Manual Del Usuario página 14

BP7272-4 HF1160.qxp_BP7272 9/10/15 9:44 PM Page 14
6.4
Pull existing wall switch out from the wall outlet box.
Disconnect the existing wall switch wires from the wires in
the outlet box by removing the the two wire connectors
(discard connectors) (Figure 22).
6.5
Set the new Wall Control in the OFF position (full counter-
clockwise) (Figure 23).
Pull the knob of the Wall Control (retain for future use).
6.6
Connect the Wall Control BLACK wire to the Fan/Motor
Lead (BLACK or RED) wire using a new wire connector
NOTE: Use only the wire connectors supplied with the
(supplied) (Figure 24).
new Wall Control to secure electrical connections.
6. Wall Control Installation
(Continued)
WALL OUTLET BOX
WIRE
CONNECTOR (2)
Figure 22
SCREWS (2)
KNOB
WALL CONTROL
Figure 23
FAN/MOTOR BLACK
OR RED WIRE
WIRE
CONNECTOR
WALL
CONTROL
BLACK WIRE
WALL CONTROL
Figure 24
14
NEUTRAL LEAD WIRES
EXISTING WALL SWITCH
TO FAN MOTOR
LOAD
TO 120VAC
SOURCE
HOT
U.L. Model No.: HF1160-2