Removing The Rechargeable Battery - Philips FC8715 Manual Del Usuario

English
14

Removing the rechargeable battery

Warning: Only remove the rechargeable battery when you discard the appliance. Make
sure the battery is completely empty when you remove it.
To remove the rechargeable battery, follow the instructions below. You can also take the robot to a
Philips service center to have the rechargeable battery removed. Contact the Philips Consumer Care
Center in your country for the address of a service center near you.
1 Start the robot from a place somewhere in the room and not from the docking station.
2 Let the robot run until the rechargeable battery is empty to make sure that the rechargeable
battery is completely discharged before you remove it and dispose of it.
3 Undo the screws of the battery compartment lid and remove the lid (Fig. 46).
4 Lift out the rechargeable battery and disconnect it (Fig. 47).
5 Take the robot and the rechargeable battery to a collection point for electrical and electronic
waste.
Troubleshooting
This chapter summarizes the most common problems you could encounter with the appliance. If you
are unable to solve the problem with the information below, visit www.philips.com/support for a list
of frequently asked questions or contact the Consumer Care Center in your country.
Problem
The robot does not start
cleaning when I press the
start/stop button.
The robot does not
respond when I press
one of the buttons.
The warning indicator
lights up solid red.
Possible cause
The rechargeable battery is
empty.
The robot is in deep sleep
mode.
The rechargeable battery is
empty.
One or both wheels are stuck.
One or both side brushes are
stuck.
The dust container is not
present or is not placed
properly.
Solution
Charge the rechargeable battery (see
chapter 'Preparing for use').
Press the start/stop button for 1 second
to switch on the robot. When you press
the start/stop button briefly again, the
robot starts cleaning. If the battery is
completely empty, place the robot on
the plugged-in docking station.
Place the robot on the plugged-in
docking station. After a few seconds,
you will hear a beep and the display
lights up.
Remove the fluff, hair, thread or wire
that is caught around the wheel
suspension.
Clean the side brushes (see chapter
'Cleaning and maintenance').
When the dust container is not present
or is not placed properly, the warning
indicator lights up solid red and the
robot stops working. Place the dust
container in the robot in the robot
properly.