Tabla De Contenido; Installation - Polar Power Output Sensor Manual Do Usuário

CONTENTS
INSTALLATION .......................................................... 3
Installing the power sensor .................................... 4
Installing the chain speed sensor ........................... 5
Installing the speed sensor ..................................... 6
Installing the bike mount ....................................... 7
Battery replacement ................................................ 7
HOW TO USE ............................................................ 8
Your Polar Power Output Sensor ........................... 8
Precautions. ............................................................ 10
Troubleshooting .................................................... 10
Technical specification .......................................... 11
Warranty ................................................................ 11
Power.output.GBR A 2-3
2

INSTALLATION

The Polar Power Output Sensor measures pedalling power, left/
right balance (LRB describes the share of power output of left and
right as a percentage), pedalling index (PI describes how evenly
power output was produced during a cycle round), speed, cadence
and distance when cycling. No other use is intended or implied.
The Polar Power Output Sensor is compatible with the Polar S710™ heart rate
monitor and with bikes with a rear derailleur. It is designed especially for road
cycling but it is also suitable for most mountain bike types. However, the wires
can not take strong external stress. Also, installation may be more difficult on
mountain bikes than on road bikes.
Before attaching the rubber pads for the sensors or the magnets to the bicycle,
the area in question should be cleaned and dried thoroughly.
If the cable ties are too short for your bicycle, join two of them together to make
them longer.
For more instructions on how to use the Polar Power Output Sensor, please refer
to the user's manual of the Polar S710 heart rate monitor.
3
18/1/01, 9:35