Precautions; Troubleshooting; Technical Specification; Warranty - Polar Power Output Sensor Manual Do Usuário

Precautions

• Before you start cycling, check that no wires affect your safety when cycling
and that your handlebars turn normally, brakes and gears function properly
etc. Also, carefully ensure that all sensors are installed securely and no
surplus wires are hanging loosely.
• Please note that installation and maintenance not carried out according to
this manual may result in a serious accident.
• The sensors contain strong magnets which may damage diskettes, magnetic
cards such as credit cards, or other electromagnetic equipment.
• Do not immerse the power output sensor in water.
• Avoid hard knocks as these may damage the sensor.
• Do not wash the device with a pressure washer.

Troubleshooting

• Check that the wristwatch receiver is correctly installed on the bike mount
and the metal pins on the bike mount make solid contact with the back
cover of the wristwatch receiver.
• Check that you have set the correct cycling settings in your wristwatch
receiver.
• Iron spokes and bicycle parts may cause irregular readings.
• If the 00 reading is constant, you may have exceeded 300 riding hours and
the battery in the power output sensor needs to be replaced.
• If there is no speed reading, check the correct position of the speed
sensor with the spoke magnet.
• If there is no cadence reading, check the correct position of the
power sensor with the crank magnet.
Power.output.GBR A 10-11
10

Technical specification

• Operating temperature 0 °C to +60 °C / 32 °F to 140 °F
• Battery type: CR 123A (1200 mAh)
• Battery life: average 300 riding hours
• Accuracy of power output measurement: ±5% (range 75-2000W)
• Weight of the sensors and the bike mount: 197 g (including battery)
• Splash-proof
Measurement ranges
• Average power: 0 - 2000 W
• LR balance: 1 - 99 %
• Pedalling index: 0 - 100 %
• Speed: 0 - 120 km/h (75 mph)
• Cadence: 0 - 255 rpm

Warranty

• Polar Electro Oy warrants to the original consumer/purchaser of this
Polar Power Output Sensor that the product will be free from defects in
material or workmanship for one year from the date of purchase. Please
keep the receipt, which is your proof of purchase!
• Warranty does not cover sensor battery, damage due to misuse, abuse,
accidents or negligence of the precautions; improper maintenance,
commercial use, cracked or broken cases.
• Warranty does not cover damage or consequential damage caused
by service not authorised by Polar Electro Oy.
• During the warranty period the product will be either repaired or
replaced at an authorised service centre free of charge.
• This warranty does not affect the consumer's statutory rights under
applicable national or state laws in force, or the consumer's rights
against the dealer arising from their sales/purchase contract.
Copyright © 2001 Polar Electro Oy, FIN-90440 KEMPELE, Finland.
All rights reserved. No part of this manual may be used or reproduced in any
form or by any means without prior written permission of Polar Electro Oy.
Polar logotype is a registered trademark and Polar Power Output Sensor is a
trademark of Polar Electro Oy.
Patents pending.
11
18/1/01, 9:35