Connecting The Base - Telefunken TB 300 City Guia De Inicio Rapido

Important information
This document is only a quick-start guide. Full
operating instructions are available on the
website www.telefunken-digital.com.
Box contents
 1 cordless handset
 1 telephone base
 1 AC adapter
 1 RJ11 telephone cord
 2 rechargeable AAA NiMH batteries
 1 quick-start guide
Siting the base
A site should be chosen with the following
characteristics:
 A flat and stable surface
 At most 2 metres from a power outlet and a
telephone jack
 At least 1 metre from any other electronic
appliance to avoid interference
 Out of direct sunlight and a sufficient
distance from any heat source
 Away from any wet or damp area, such as a
bathroom
Note: since the base and the portable handset
communicate via radio waves, it is important
that the base is located in an open area to
ensure the best possible signal. The normal
range is approximately 300 metres when there
is a direct line of sight to the base, and
approximately 50 metres when the base is
indoors and the phone is outdoors. Thick
concrete walls significantly reduce this range.
The symbol on the portable handset
indicates when you are in range of the base.
Whenever you are outside range of the base,
the symbol blinks, and a warning tone is
emitted.

Connecting the base

1. Under the base, plug the power cord
holding a clear connector in the plug
labelled .
2. Connect the other end of the power cord
into the power wall outlet. The device
switches on, as indicated by the green light
from the base.
3. Under the base, connect the telephone jack
to the plug labelled
into the telephone connector plug. Then
plug the connector to the telephone wall
jack.
4. Verify that the green light of the base is lit.
Recharging the handset
1. On the handset, slide the cover and insert
the 2 NiMH batteries supplied. Always
observe the direction of insertion. Close the
lid.
2. Place the handset on the base and allow
charging for at least 24 hours before its first
use, until the handset icon indicates
3. If necessary, do the same for other
handsets.
2
and the other end
.