Declaration Of Conformity - Hoover Rogue Manual De Usuario

DECLARATION OF CONFORMITY

This device complies with Part 15 of the FCC Rules / Industry Canada license-exempt RSS standard(s) .
Operation is subject to the following two conditions: (1) this device may not cause harmful inteference,
and (2) this device must accept any interference received, including interference that may cause
undesired operation .
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the transmitter by industry Canada . To reduce
potential radio interference to other users, the antenna type and its gain should be chosen that
the equivalent isotropically radiated power (e .i .r .p .) is not more than that necessary for successful
communication .
MPE REMINDING
To satisfy FCC / IC RF exposure requirements, a separation distance of 20 cm or more should be
maintained between the antenna of this device and persons during device operation .
To ensure compliance, operations at closer than this distance is not recommended .
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment .
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules . These limits are designed to provide reasonable protection against harmful
interference in a residential installation . This equipment generated uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications . However, there is no guarantee that interference will not occur in a particular
installation . If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocated the receiving antenna .
• Increase the separation between the equipment and receiver .
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected .
• Consult the dealer or an experienced radio/TV technician for help .
23