Unpacking The Unit; Disposing Of The Unit; Assembling The Appliance; Dry Vacuuming - Hoover S 5135 Manual Del Usuario

accessories or to the cable (special cable required);
have repairs done only by an authorised customer
service station, because modifications to the
appliance can pose a risk to your health.
Ensure that only original spare parts and accessories
are used.
• Do not expose the appliance to the elements,
humidity or heating sources.
• After wet vacuuming, empty the collecting bin
immediately.

Unpacking the Unit

• Unpack the unit and inspect it for signs of shipping
damage. Check that all items that should be
included are present. Immediately notify your
dealer or out customer-service department if you
find any damage or if any items are missing.
• Save the original packing carton, since you can use
it for storing the unit and might need it to return the
unit to your dealer or a HOOVER Customer-Service
Center for servicing.

Disposing of the Unit

Dispose of the appliance according to local regulations
and pull out and cut off the mains cable beforehand.
Assembly
Undo the snap-on fasteners and lift the motor
A
block.
B Place footring with the 4 holes to match with the
holes on the underside of tank and fix it by
plugging in the fixing elements.
Push the castor wheels and the pegs into the
footring until they snap into place.
Press snap catch (19) in the side of the motor
C*
head and unlock.
K* Assembly float and float holder.
7

Dry vacuuming

After wet vacuuming, the appliance must be
absolutely dry; dry off the flexible hose or tubes
if necessary beforehand.
Never dry vacuum without filters or
with damaged filters.
Assemble the foam premotor filter, premotor
D
paper filter and clamping ring and fasten them
with the locking clips.
Press the filter bag on the suction connection
E
firmly and lay it against the wall of the collecting
bin.
Place the motor block on top and secure it by
F
means of snap-on fasteners.
G Connecting the flexible hose. Remove the hose by
turning the hose connecting piece and
withdrawing the hose.
Assemble the accessories you require.
Connect the mains cable.
H Turn the appliance on with the On/Off switch (5).
Suction control (11, figure J) allows you to vary
the suction power.
– Sliding air trap closed = full suction power
– Sliding air trap open = reduced suction power
Dependant on equipment:
Appliance with plug box.
Electric tools with a rating in accordance with the
rating printed on the plug box can be connecting up to
the appliance plug box (6).
This plug box is ready for service as soon as the
vacuum cleaner has been connected to the main
voltage.
* Feature varies according to model