Symbols Used In This Manual; Symbols On The Device; Important Safety Information; Intended Use - Flex LD 16-8 125 R Instrucciones De Funcionamiento Originales

Contents
Symbols used in this manual . . . . . . . . . 14
Symbols on the device . . . . . . . . . . . . . . 14
Important safety information . . . . . . . . . 14
Noise and vibration . . . . . . . . . . . . . . . . 17
Technical data . . . . . . . . . . . . . . . . . . . . 18
Overview . . . . . . . . . . . . . . . . . . . . . . . . 19
Instructions for use . . . . . . . . . . . . . . . . 20
Maintenance and care . . . . . . . . . . . . . . 23
Disposal information . . . . . . . . . . . . . . . 24
conformity . . . . . . . . . . . . . . . . . . . . . 24
Exemption from liability . . . . . . . . . . . . . 24

Symbols used in this manual

WARNING!
Denotes impending danger. Non-
observance of this warning may result in
death or extremely severe injuries.
CAUTION!
Denotes a potentially dangerous situation.
Non-observance of this warning may result
in injury or damage to property.
NOTE
Denotes hints on use and important
information.

Symbols on the device

Before switching on the power
tool, read the operating manual.
Wear protective goggles.
Disposal information for the
old tool (see page 24).
14
LD 16-8 125 R / LDE 16-8 125 R

Important safety information

WARNING!
Before using the power tool, please read the
following and act accordingly:
These operating instructions
-
The "General safety instructions" on
-
the handling of power tools in
the enclosed booklet (leaflet no.:
315.915)
The currently valid site rules and the
-
regulations for the prevention of
accidents
This power tool is state of the art and has
been assembled in accordance with the
acknowledged safety regulations.
Nevertheless, when in use, the power tool
may pose a danger to life and limb of the
user or a third party, or the power tool or
other items could be damaged. The power
tool may be operated only
for its intended use,
-
in perfect working order.
-
Faults which compromise safety must be
repaired immediately.

Intended use

The renovation sander LD 16-8 125 R /
LDE 16-8 125 R is designed
- for commercial use in industry and trade
- for dry sanding and smooth finishing
concrete, plaster, screed, sandstone,
fireclay and tarmac
- for sanding off paint and adhesive
residue on concrete or screed
- for use with diamond tools that are
offered by FLEX for these power tools
and are authorised to run at a speed of at
least 9000 rpm.
It is not permitted to use cutting discs,
rubbing discs, flap discs or wire brushes.
When using the renovation sander
LD 16-8 125 R / LDE 16-8 125 R, connect a
class M dust extractor.