To Prevent Damage; Notice For The Blue/White Lead - Pioneer AVIC-F320BT Manual Del Usuario

Section
03 Connecting the System

To prevent damage

WARNING
! Use speakers over 50 W (output value)
and between 4 W to 8 W (impedance value).
Do not use 1 W to 3 W speakers for this
unit.
! The black lead is earth. Please earth this
lead separately from the earth of high-cur-
rent products such as power amps. Do not
earth more than one product together
with the earth from another product. For
example, you must separately earth any
amp unit away from the earth of this navi-
gation system. Connecting earths to-
gether can cause a fire and/or damage the
products if their earths became detached.
! When replacing the fuse, be sure to only
use a fuse of the rating prescribed on this
product.
! When disconnecting a connector, pull the
connector itself. Do not pull the lead, as
you may pull it out of the connector.
! This product cannot be installed in a vehi-
cle without ACC (accessory) position on
the ignition switch.
ACC position
! To avoid short-circuiting, cover the discon-
nected lead with insulating tape. It is espe-
cially important to insulate all unused
speaker leads, which if left uncovered may
cause a short circuit.
! Attach the connectors of the same colour
to the corresponding coloured port, i.e.,
blue connector to the blue port, black to
black, etc.
! Refer to the owner's manual for details on
connecting the power amp and other units,
then make connections accordingly.
6
Engb
No ACC position
! Since a unique BPTL circuit is employed,
do not directly earth the * side of the
speaker lead or connect the * sides of the
speaker leads together. Be sure to connect
the * side of the speaker lead to the *
side of the speaker lead on this navigation
system.

Notice for the blue/white lead

! When this unit is turned on, a control sig-
nal is output through the blue/white cable.
Connect it to an external power amp's sys-
tem remote control or the vehicle's auto-
aerial relay control terminal (max. 300 mA,
12 V DC). If the vehicle is equipped with a
glass aerial, connect the cable to the aerial
booster power supply terminal.
! Never connect the blue/white cable to an
external power amp's power terminal. Also,
never connect it to the power terminal of
the auto aerial. Otherwise, battery drain or
malfunction may result.
! Be sure not to use this lead as the power
supply lead for the auto-aerial or aerial
booster. Such connection could cause ex-
cessive current drain and malfunction.