Fitting The Work Load - Festo HME-16-100 Serie Instrucciones De Utilizacion

HME−...
Further mounting possibilities can be found in the Festo catalogue or on the Festo
Internet page and the necessary accessories can be found in the chapter Acces
sories" (Internet address see last page of these operating instructions).
Note the maximum permitted tightening torque for the fastening screws of
S
5.9 Nm (M5).
The centring recess has dia. 9 mm (tolerance H7).
Tighten the fastening screws evenly.
S

Fitting the work load

Please note
The module will not function correctly if
the front plate is distorted.
S Make sure that the screws (A) at the
lower end of the front plate are not
loosened.
Take into account the permitted forces
S
and torques (see chapter Technical
specifications").
The forces and torques represented in the
graph result from your application. These
depend on:
weight forces (work load/mass)
inertial forces (work load/mass)
feed force
counter forces.
The forces and torques on the roller
bearing guide result from the relevant
position and dynamics (braking/acceleration).
32
(A)
Fig. 8
Fig. 9
Festo HME−... 0604NH English