Specifications; Specifications Subject To Change Without Notice - Rockford Fosgate PBR300X1 Instalación Y Operación

S
PECIFICATIONS
MODEL- PUNCH
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
4 Load Mono
2 Load Mono
1 Load Mono
Dimensions: Height
Width
Length
External Battery Fuse Rating
"A" Weighted Signal to Noise Ratio
Referenced to 1 Watt into 4 ohms
"A" Weighted Signal to Noise Ratio
Referenced to rated output into 4 ohms
Crossover Slope
Crossover Frequency
Frequency Response
Signal Voltage Adjustment Range(RCA Input)
Signal Voltage Adjustment Range(Speaker Input)
Protection
Equalization PEQ (Punch Equalization)
Input Impedance
Operating Voltage
CMRR (Common Mode Rejection Ratio)
Damping Factor
THD+N (Total Harmonic Distortion+Noise)
These specifications are Amplifier Power Standard CEA-2006 Compliant

Specifications subject to change without notice

10
PBR300X1 PBR500X1
75 Watts x 1 175 Watts x 1
150 Watts x 1 300 Watts x 1
300 Watts x 1 500 Watts x 1
1.53" (3.90cm) 1.53" (3.90cm)
4.25" (10.8cm) 4.25" (10.8cm)
6.75" (17.2cm) 8.25" (20.9cm)
30A 80A
≥85 dB
≥105 dB
12dB/octave Butterworth
variable from 35Hz to 250Hz
20Hz to 250Hz ±1.0dB
Variable from 150mV to 4V
Variable from 400mV to 11V
Short circuit protection shut downs the amplifier in
case of very low impedance, shorted speaker wires, or
shuts down the amplifier in case of overheating.
Variable from 0dB to +18dB @ 45Hz
20K ohms
9 to 16 Volts DC
>55dB @ 1kHz
< 0.2% @ 4 ohm
>200