Migatronic RALLY MIG 161i Guía De Usuario página 8

Connection and operation
Inching
The function is used
for wire inching
e.g. after change of
wire. Wire inching
starts by pressing the
green key pad and
simultaneously triggering the torch trigger. Wire
inching continues even though the green key pad
has been released. It does not stop until the torch
trigger has been released again.
Change of wire liner
Selecting welding polarity
Polarity reversal is recommended for certain types
of welding wire, in particular Innershield welding
wire. For recommended polarity, please refer to
the welding wire packaging.
Change of polarity:
1. Disconnect the machine from the mains
supply.
2. Dismount the milled nuts at the poles (fig. 1).
3. Reverse the cables (fig. 1).
4. Mount the milled nuts (fig. 1).
5. Exchange earth cable from minus to plus (fig.
2).
6. Connect the machine to the mains supply.
1
Change of polarity
8
All manuals and user guides at all-guides.com
Switch on, press, weld
i
Welding program setting
Cu
• Switch on the welding machine on the main
CrNi 1.0
Al 0.9
Fe Mix 0.8
switch (2)
Fe CO
0.6
2
• Select process
• Select type of material and wire diameter
• Set one of the following parameters:
welding current, wire feed speed or thickness
of material
• Trim the arc length, if required
• Adjust secondary parameters.
• The machine is now ready to weld
Software reading
• Insert the SD-card
in the slide in the
right side of the
machine.
• Turn on the
machine.
• The display
flashes shortly
with three lines.
• Wait until the set current is displayed.
• Turn off the machine and remove the SD card.
• The machine is now ready for use.
2
It is necessary to read software inside the new
control unit by means of a SD card, if the control
unit has been exchanged.
The software can be downloaded from
http://migatronic.com/login
i
Cu
CrNi 1.0
Al
0.9
Fe Mix 0.8
Fe CO 0.6
2
Please read your
quickguide
WARNING
Voltage is present on the welding
wire when pressing the welding
hose trigger.