Courtesy Lights - Key Automation 900CT-101 Manual De Instrucciones

tiM TIMER the relay closes when a remote control arrives on channel 4 and opens after the set time
biSt BISTABLE the relay changes each time a remote control arrives on channel 4
Mon MONOSTABLE the relay keeps closed until a signal given by the remote control on channel 4 arrives.
Automatic closing
During the automatic operation, the control unit will automatically close
the gate when a set-up time expires.
The Start command, if enabled by St.PA menu, allows closing the gate
before the set up time expires.
In semi-automatic operation, that is to say, if the automatic closing
function is disabled by setting the value to zero ('no' will be displayed),
the gate can be closed through the start command only: in this case,
St.PA menu setup will be ignored.
If the control unit receives a Stop command when the gate is in
pause, it will automatically pass to the semi-automatic operation.
Closing after transit
During the automatic operation, the pause count down starts from the
set up value each time a photocell operates during the pause.
If the photocell operates during the opening time, this time will be
immediately stored as pause time.
This function allows having a fast closing as soon as transit through
the gate is completed, therefore, a time shorter than CH.AU is
generally used.
Ch.AU will be used when 'no' is set up.
As for semi-automatic operation, this function is not active.
Pause after transit
In order to let the gate open for the shortest possible time, it is
possible to stop the gate once the passage before the photocells is
detected. If the automatic working is enabled, the time of the pause is
Ch.tr.
28

Courtesy lights

Thanks to the output COURTESY LIGHT
the control unit 900CT-101 allows the
connection of an electric appliance (e.g.
courtesy light or garden lights), controlled
automatically or by means of the special
transmitter key.
t.LUC the relay closes when a start or a
pedestrian start control is given
and opens after the set time. It
works in the same way whit a
remote control on channel 4.
CiCL the relay keeps closed during the
whole opening/closing phase. In
case of intervention of a remote
control on channel 4, it keeps
closed for the time set by item
T.LUC
AUS auxiliary output with settable
operation logic
In this last case, the COURTESY LIGHT
output becomes an auxiliary output to
which it is possible to link one of the
following operation logics: