WEG CFW-11 Guía De Instalación, Configuración Y Operación página 4

To correctly install modules IOE-01, IOE-02 and IOE-03, follow the steps below:
Step 1: While the drive is powered off, remove the front cover of the CFW-11
(figure 2);
Step 2: Carefully connect the module into slot 1 (figure 3(a));
Step 3: Place and fasten the fixing screw of the module (figure 3(b));
Step 4: Connect the cables of the sensors in the XC12 (IOE-01), XC13 (IOE-02)
and XC14 (IOE-03).
6
a
Figure 2 - Removal of the front cover
a
Figure 3 - Installation of the optional module into slot
b
c
b