Cable Recommendations To Connect The Sensors; Insulation; First Time Start-Up - WEG CFW-11 Guía De Instalación, Configuración Y Operación

2.2 Cable Recommendations to Connect the Sensors

Use shielded cables with wire gauge between 0.14 mm
(15 AWG). Connect the shield in the control ground plate. Refer to the CFW-11
User's Guide for further details.

2.3 Insulation

The circuit connected in the sensors have strong insulation from the others circuits
in the control board. But it's recommended that all the sensors be always isolated
from the live parts of the motor.

3. FIRST TIME START-UP

Step 1: After install the module and connected your cables, energize the inverter;
Step 2: Check if the module was correctly identified by the control: 25xx (IOE-01),
23xx (IOE-02) or 27xx (IOE-03);
Step 3: Set up the parameters related with the used module according with the
application needs. Refer to the CFW-11 Programming Manual for further
details.
10
(26 AWG) and 1.5 mm
2 2