Before Installing This Unit; Installation With The Holder - Pioneer AVH-X8500BT Manual De Instalación

Connecting the units
Installing the HDMI cable holder
% Position the HDMI cable holder to insert
its two lower tabs into the groove of this
product, and then tighten the screw (3 mm ×
5 mm) to fix the HDMI cable holder.
2
1
3
3
4
1 HDMI cable holder
2 Screw (3 mm × 5 mm)
3 Tab
4 Groove
! Use the HDMI cable holder when you con-
nect this product with the separately sold
App Connectivity Kit (CD-IH202/CD-AH200).
! Never grip the holder tightly or use force
when removing or attaching.
Installation
Notes
! Check all connections and systems before
final installation.
! Do not use unauthorized parts as this may
cause malfunctions.
! Consult your dealer if installation requires
drilling of holes or other modifications to the
vehicle.
! Do not install this unit where:
— it may interfere with operation of the vehicle.
— it may cause injury to a passenger as a result
of a sudden stop.
! Do not install the display where it may (i) ob-
struct the driver's vision, (ii) impair the per-
formance of any of the vehicle's operating
systems or safety features, including air
bags, hazard lamp buttons or (iii) impair the
driver's ability to safely operate the vehicle.
! The semiconductor laser will be damaged if
it overheats. Install this unit away from hot
places such as near the heater outlet.
! Optimum performance is obtained when the
unit is installed at an angle of less than 30°.
! When installing, to ensure proper heat dis-
persal when using this unit, make sure you
leave ample space behind the rear panel and
wrap any loose cables so they are not block-
ing the vents.
Leave ample
5 cm
space
5 cm
5cm cm

Before installing this unit

% Remove the holder.
1
1 Holder
(factory-supplied part)

Installation with the holder

1 Install the holder into the dashboard.
After inserting the holder into the dashboard, se-
lect and bend the tabs appropriate to the thick-
ness of the dashboard material. (Install this unit
as firmly as possible using the top and bottom
tabs. To secure this unit, bend the tabs 90 de-
grees.)
Section
01
02
7
En