Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Notes
! Check all connections and systems before
final installation.
! Do not use unauthorized parts as this may
cause malfunctions.
! Consult your dealer if installation requires dril-
ling of holes or other modifications to the vehi-
cle.
! Do not install this unit where:
— it may interfere with operation of the vehi-
cle.
— it may cause injury to a passenger as a re-
sult of a sudden stop.
! Do not install the display where it may (i) ob-
struct the driver's vision, (ii) impair the perfor-
mance of any of the vehicle's operating
systems or safety features, including air bags,
hazard lamp buttons or (iii) impair the driver's
ability to safely operate the vehicle.
! The semiconductor laser will be damaged if it
overheats. Install this unit away from hot
places such as near the heater outlet.
! Optimum performance is obtained when the
unit is installed at an angle of less than 30°.
! When installing, to ensure proper heat disper-
sal when using this unit, make sure you leave
ample space behind the rear panel and wrap
any loose cables so they are not blocking the
vents.
Leave ample
5 cm
space
5 cm
5cm
cm
Before installing this unit
% Remove the holder.
1 Holder
(factory-supplied part)
Installation with the holder
1
Install the holder into the dashboard.
After inserting the holder into the dashboard,
select and bend the tabs appropriate to the
thickness of the dashboard material. (Install
this unit as firmly as possible using the top
and bottom tabs. To secure this unit, bend the
tabs 90 degrees.)
1
2
1 Dashboard
2 Holder
(factory-supplied part)
1
En
Section
02
11
Publicidad
Tabla de contenido
