cecotec HYDROBOOST 10200 LIBERTY PRO Manual De Instrucoes página 41

ENGLISH
high-impact stream to a 60° wide fan spray.
Fig. 20
This appliance offers 2 modes:
Focused mode
The angle of the water stream coming out of the nozzle may be adjusted with the pulverisingng
nozzle. Turn the nozzle to select the focused stream, which has a high impact on the cleaning
surface and results in maximum deep cleaning in a concentrated area. This narrow high-
impact stream must be used cautiously, as it may damage some surfaces.
Note: Pay special attention when cleaning delicate surfaces such as bodywork o wheel rims,
lacquered surfaces, wood, paint, etc.
Fig. 21
Spray mode
Turn the pulverising nozzle to select the flat-fan pattern. A wide stream will distribute the
impact of water over a larger area, resulting in excellent cleaning action with a reduced risk of
surface damage. Large surface areas can be cleaned more quickly using a wider stream.
Fig. 22
Product operation
Note: The motor on this pressure washer does not run continuously. It only runs when the
trigger of the spray gun is squeezed. After following the start-up procedures in this manual,
press the safety-lock button and the trigger at the same time, then release the safety-lock
button. The device will operate as long as the trigger is pressed.
Nozzle cleaning
A clogged or partially clogged nozzle can cause a significant reduction of water coming out of
the nozzle and cause the unit to pulsate while spraying. To clean out the nozzle:
Turn off and unplug the unit.
Turn off water supply. Relieve any pressure trapped in the high-pressure by squeezing the
trigger 2-3 times.
Separate the lance from the gun.
Rotate the nozzle to the narrow stream setting.
Use any type of pointed element such as an unfolded paper clip to clean the nozzle. Insert the
wire into the nozzle hole and move back and forth until debris is dislodged.
Fig. 23
Remove debris by back-flushing water through the nozzle. To do this, point the end of a garden
hose (with water running) to the nozzle's end for 30-60 seconds.
Angle from the high-pressure hose to the cleaning surface
41
HYDROBOOST 10200 LIBERTY PRO