ABB Orion2 Manual Del Usuario página 7

Functions
A slot situated on the front side of the receiver and easily opened with a screwdriver, facilitates the access to the
internal dip-switches
To open the lid, insert the tip of a flat screwdriver into the groove of the hinged lid and lever it up slightly until the snap
happens. Open the lid totally (135°). A light brake maintains the lid in open position. To close the lid, press on the
zone around the groove until the closing snap.
The dip-switches allows to set the functions as described in the following table:
Dip-switches
1 and 5
2 and 6
3 and 7
4 and 8
* Factory default configuration.
NB: As shown in the figure and in the previous table, each function is associated with two different dip-switches. The
two different dip-switches associated with a particular function must be configured in the same way.
Warning! An infinite muting (timeout = ) is not compliant with EN 61496-1:2013. Therefore, all possible risks must be
considered and related precautions undertaken before selecting the option "".
Warning! The device does not accept configuration changes during normal operation. A change is taken into account
after the next powering of the device. Therefore, the management and the use of the configuration dip-switches
should be performed with great care.
.
2TLC172297M0201
2015-09-10
Dip-switches
Function
Muting timeout
Muting
EDM
Reset
ON
1 2 3 4 5 6
ON*
10 min.
T/X-muting
Deactivated
Automatic
7
7 8
OFF

L-muting
Activated
Manual
www.abb.com/jokabsafety