Technical Specifications - Sinbo SVC 3466 Manual De Instrucciones

starts to decrease, turn off the vacuum cleaner then clean all the air filters.
20. Do not try to use the broken appliance.
21. Do not direct the vacuum cleaner towards people and animals.
22. Never immerse the body of the appliance in water and prevent pouring water on the appliance.
23. Keep the appliance in a dry and cool place.
24. Acids, dissolvent, solvent, acetone and very hot substances, wastes harmful for health, toxic
substances ( chlorine bleacher, ammonium, drain opener etc),hard, sharp objects such as glass, bold,
coins give harm, do not use these kinds of substances for cleaning.
25. Contact with your nearest authorized service for repair and spare part.
NOTE: The descriptions on the appliance or determined in the instruction manual can be changed
without prior notice.

TECHNICAL SPECIFICATIONS

Operation tension: AC230V
Frequency: 50 Hz
Power consumption: 2000 W
Class: Class II
PARTS OF VACUUM CLEANER
1. ON/OFF switch, 2. Carrying handle, 3. Body, 4. Power cable, 5. Air outlet grille, 6. Top sponge, 7. Disc
8. Bottom sponge, 9. Water container cover, 10. Water filter pipe, 11. Water screen, 12. Vacuum bag
container, 13. Transparent water container, 14. Locking clips, 15. 360° Rotating wheels, 16. Wheel body
17. Big wheel, 18. Suction hose, 19. Extension pipes, 20. Carpet apparatus, 21. Curtain apparatus,
22. Narrow mouth edge, 23. Dust bag
USE
WARNING: DO NOT PUT WATER INSIDE YOUR APPLIANCE IN THE MAX. LEVEL
WET CLEANING
1. While putting or removing the accessories of the vacuum cleaner, you must unplug it from the wall
socket.
2. In wet cleaning, put the water filter pipe to the water screen part and put water filter into the dust
bag (Picture 1)
3. Install the upper and bottom sponges on the disk. (Picture 2)
4. After filling the water, first, place the water container cap and disc part as two arrows corresponds
each other. (Picture 3)
5. Install water container cap. (Picture 4)
6. After placing the upper body on the water container cap, close the clips.
7. Install the flexible hose to the air inlet channel; push it until you hear a "click" sound, indicating that
it comes to the locked position (Picture 5).
Note: After these steps, you can use the apparatus you want according to the cleaning type.
8. Push the pipe to the curved rod/hose extension part. (Picture 7)
9. Push the pipe to the narrow inlet edge. (Picture 8)
10. Push the pipe to the carpet apparatus. When pressed slightly to the part where there is a floor
brush, it can be used with or without brush. (Picture 9)
11. Push the pipe to the screen apparatus (Picture 10)
12. You can adjust the suction power by moving the mechanic cleaning power adjustment slide on the
inclined pipe. (Picture 11)
Warning :
NEVER wash the filter of the appliance in the washing machine. For drying, do not use the drying part
of hair dryer and washing machine.
• After the filters are dried completely, put it into its place. NEVER use you appliance without placing
the filters into their place.
- 9 -