Sinbo SVC 3466 Manual De Instrucciones página 11

* When you install the filters without drying completely, dust will stick to the filters and block it, the
sucking power of your product will be lost.
Note: After all apparatus are put into their places, pull the sufficient length of cable outside. The red
mark on the cable indicates the ideal cable length. Do not pull the cable more from the red mark.
13. Plug in the cleaner to the wall socket.
14. Operate the cleaner on flat surfaces; never use it in inclined surfaces. To open the electric vacuum
cleaner, press On/Off button. Vacuum cleaner is ready for use.
15. The cable winder of our appliance is automatic. When you pull and leave the cable once, it will stay
as stable, when you pull and leave it for the second time, it will be winded automatically to the cable
hole.
USE
DRY CLEANING
1. For dry cleaning, remove the water filter pipe (10) and water screen (11) from the appliance.
2. Install the dust bag which came with the appliance to the dust back container. (Picture 6)
3. You can operate your appliance as dry by installing the other parts of the appliance as explained in
the wet cleaning
Using apparatus
Carpet apparatus; It is used for cleaning hard and soft surfaces as dry. When the brush is out you can
clean hard surfaces, when the brush is inside, you can clean soft surfaces like carpet.
Screen apparatus; It is used for cleaning surfaces such as pillow, mattress, and sofa. To use the wide
edge apparatus, push the pipe to the apparatus.
Narrow edge apparatus; It is used for cleaning radiator gaps, edge and folded surfaces. To use marrow
edge apparatus, push the pipe inside the apparatus.
CLEANING AND APPARATUS
Warning: Always unplug the vacuum cleaner from the wall socket before cleaning and maintenance.
1. Unplug the vacuum cleaner.
2. Open the clips of the vacuum cleaner.
3. Move the upper body by grabbing it from the carrying handle.
4. Remove the cover, disc and sponges of the water container. Shake the water drops under the container
cap towards the container then wipe the container cover and disc with a cloth.
5. Wash the bottom and upper sponges with tap water and before installing it back to the vacuum
cleaner, be sure that it is dried well.
6. Empty the water in the container. After every use, in order to prevent bad odor, you must wipe your
appliance.
7. If wet surface cleaning is made, it is recommended that, extension pipe and sweeping cap should be
hang for drying.
8. Clean the outer surface of the vacuum cleaner with a damp cloth.
9. Clean hair, feather, wool and similar objects collected from the floor and carpet.
WARNING: Vacuum hose of the cleaner should be open and there should be no blockage. Otherwise,
motor will heat too much and get damaged.
- 10 -