Pentair LR-1500 Manual De Instalación Y Operación página 2

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING SPECIFICATIONS
Temperature Range:
Pressure Range:
Service Flow Rate @ 60 psi (4.1 bar):
Rated Service Life:
Dimensions:
Weight (System and Cartridge):
PARTS INCLUDED
Filter System with Cartridge
Installation Hardware Kit:
- 3/8" (white and blue) tubing
- Sump Wrench
- Connectors, Female, 3/8" x 3/8"
- Mounting Screws
- Silicone Lubricant Packet
TOOLS AND MATERIALS REQUIRED
Safety glasses
Adjustable wrench
Tube cutter or utility knife
Hand or electric drill (cordless recommended)
1/4" drill bit
• 2 •
40°F–100°F (4.4-37.8°C)
40–125 psi (2.75-8.62 bar)
2.5 GPM (9.46 LPM)
1500 gallons (5678 liters)
4.88" x 13" x 5.25"
(124mm x 330mm x 136mm)
3 lbs. (1.36 kg.)
PRECAUTIONS
Carefully read and follow instructions.
WARNING
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate disinfection
before or after the system. System certified for cyst reduction may
be used on disinfected waters that may contain filterable cysts.
CALIFORNIA PROPOSITION 65 WARNING
WARNING
This product contains chemicals known to the State
of California to cause cancer or birth defects or other reproductive
harm.
CAUTION
System must be protected against freezing, which can
cause cracking of the filter and water leakage.
CAUTION
The rubber O-ring provides the water-tight seal
between the cap and the bottom of the housing. It is important
that the O-ring be properly seated in the groove above the
threads of the housing or a water leak could occur.
NOTES:
For cold water use only.
Make certain that installation complies with all state and local
laws and regulations.
The system must be maintained according to manufacturer's
recommendations, including replacement of filter cartridges. The
contaminants or other substances removed or reduced by this
water treatment device are not necessarily in your water. Ask
your local water municipality for a copy of their water analysis,
or have your water tested by a reputable water
testing lab.
After prolonged periods of non-use (such as during a vacation)
it is recommended that the system be flushed thoroughly. Let
water run for 5-6 minutes before using.
The filter cartridges used with this system has a limited service
life. Changes in taste, odor, or flow of the water being filtered
indicate that the cartridge should be replaced.

Publicidad

Tabla de contenido
loading

Tabla de contenido