Wheel Installing - Marzocchi MONSTER Serie Instrucciones Para El Uso Y Mantenimiento

3.3

Wheel installing

Install the wheel in compliance with the bicycle
manufacturer's instructions.
For correct fork function, please follow the
instructions here below when installing the
wheel.
• In case the fork has been disassembled from
the bike frame or the fork's legs position in the
crowns has been changed, you will have to
slightly loose the 6 bolts (E) holding the arch
(D) by means of a 4 mm hex key.
• Insert the wheel axle (A) through the right
wheel axle clamp, then the wheel and the left
wheel axle clamp.
• By using a 6 mm hex key, tighten the axle bolt
(B) located on the left side to the required
torque (see Table 1 - Tightening Torques).
• Fully compress the fork a few times.
• By using the 5 mm hex key, tighten the bolts
(C) positioned on both dropouts to the
required torque (see Table 1 - Tightening
Torques), with the 1-2-1 sequence.
• By using the 4 mm hex key, tighten the bolts
(E) with the sequence 1-2-3-2-1 to the
required torque (see Table
Torques).
Incorrect wheel alignment can misalign the
legs make them unparallel, causing the fork to
bind.
C
1 - Tightening
5 mm
C
E
A
Installation
31
4 mm
D
E
6 mm
B