Installation; Installation On The Frame; Installing The Brake System - Marzocchi MONSTER Serie Instrucciones Para El Uso Y Mantenimiento

Installation

30
3 INSTALLATION
3.1

Installation on the frame

The fork is supplied
(threadless) steer tube to be cut according to
frame size. Installing a MARZOCCHI fork on the
bicycle frame is a very delicate operation that
must be carried out by specialized personnel.
The assembling on the frame and the steer tube
adjustment must be carried out in compliance
with the headset manufacturer's instructions.
Improper installation may jeopardize the safety
of the rider. Marzocchi does not guarantee the
installation and refuses all responsibility for
damages and/or accidents that may be caused
by an incorrect assembly.
The steer tube must be pressed into the crown;
its replacement must be carried out by a
Marzocchi service center only, using the required
tools. In case of improper installation of the steer
tube into the crown, the rider might lose control of
his/her bicycle, thus resulting in serious injury.
Before assembly on the frame, make sure that
the lower crown screws are correctly tightened.
When the fork's legs are at travel's end, the "D"
distance between the lower part of the lower
crown and the dust seal must be bigger than 3
mm. The stanchion tubes clamping to the
crowns has to be done in the areas where the
diameter is bigger.
Make sure that the "H" distance is lower than
190 mm. A different position of the crowns
could damage the fork and could be causing
accidents.
3.2

Installing the brake system

Assembling the brake system is a very delicate
operation that must be carried out by specialized
personnel.
Marzocchi does not guarantee the assembly
and refuses all responsibility for damages and/
or accidents that may be caused by an
incorrect assembly.
Improper installation of the disk brake system
can overstress the caliper mountings, which
may break. The brake system assembling must
be carried out in compliance with brake
system's manufacturers instructions. Improper
installation may jeopardize the safety of the
rider.
Only use brake systems that are complying
with the fork's specifications.
with "A-Head Set"