Tabla de contenido
Publicidad
2
If air tubes are loosened while pumping.
Check if connectors are stained by oil. Take off the connectors/air tubes, make
2-1
sure to wipe off the oil and use neutral detergent to clean the parts thoroughly.
Check if air tubes are clamped during assembly. Slightly pull the tube
2-2
(as shown below) to make sure it is freely moving without clamp.
3
If the pressure meter does not function while pumping.
Check if pointer is installed correctly ( refer to page 11, step 12 )
3-1
3-2 Check if air tubes are clamped ( refer to Trouble Shooting 2-2 )
4
Check if D2 / D5 are installed in the right direction. ( refer to page17, step 2 )
D5
D2
D5
47
D2
Publicidad
Tabla de contenido
