Troubleshooting - Klarstein MisterCook Manual De Instrucciones

TROUBLESHOOTING

Problem
Plug the mains plug into the wall socket.
Press the ON/OFF button, the display
does not light.
The On/Off indicator does not light.
During operation, the heating process is
suddenly stopped.
The power cord is damaged.
Error code E1
Error code E3
Error code E4
Error code E5
Possible Solution
Check that the mains plug is plugged
into the wall socket correctly and that
the wall socket is in good condition.
Check if the display or the main board
are in good condition.
Check whether the following causes
have occurred: the surrounding
temperature is high or the set timer time
has been reached. If the overheating
protection has been started, do not put
the hotplate back into operation until
after 10 minutes. The hotplate switches
off automatically during operation after
2 hours of non-use.
Have the defective power cord replaced
by an authorized electrician with a
power cord of the same model.
Short or open circuit detection of the
temperature sensor.
A beep sounds every second and the
LED display shows a flashing "E3":
The voltage is ≥ 270 V. If the voltage is
< 260 V, press the ON/OFF button, the
infrared cooker will work or turn off.
A beep sounds every second and the
LED display shows a flashing "E4":
The voltage is ≤ 100 V. If the voltage is
> 120 V, press the ON/OFF button, the
infrared cooker will work or turn off.
The working current of the fan is too low.
EN
21