Troubleshooting - Klarstein MultiChef 4 Manual Del Usuario

TROUBLESHOOTING

Gas burner
Problem
The burner cannot be lighted or the flame
is not uniform around the burner.
The flame does not keep lighting to the
burner with thermocouple
The flame goes out while turning knob to
"Low" setting.
The cookware is not stable.
Ceramic burner
Problem
The cooking zones have become soiled.
The residual heat indicator cannot work.
Check to make sure that:
• The gas holes on the burner are not
clogged;
• All of the movable parts of burners are
fixed correctly;
• There is no air flow around the
cooking surface
• You press the knob all the way;
• You keep pressing the knob
for enough time to activate the
thermocouple.
• The gas holes are not clogged
in the area corresponding to the
thermocouple.
• The gas holes are not clogged.
• There is no air flow around the
cooking surface.
• The minimum has been adjusted
correctly (see the section entitled
"Minimum Regulation").
• The bottom of the cookware is
perfectly flat.
• The cookware is centred correctly on
the burner.
• The support grids have not been
inverted.
Check to make sure that:
This may be caused by burnt on remnants
of food. This will not affect the working
of the appliance. However, you should
make sure that the cleaning instructions
are being followed regularly.
If the cooking zone does appear to be
hotter than 60 and the residual heat
indicator has not come on, you should
call the Service Department.
EN
37