NSK isoE-LUX Manual Del Usuario página 4

NOTICE
• Sometimes dark stains are found on the optic illumination point (glass fiber end) due to a
characteristic of the product. This is not a defect of the product and it does not affect the
light projection capability of the optic illumination point.
• The performance of this product is dependent on the light source of an optic motor. Light
transmission of the product might be reduced due to maintenance or use conditions.
• Turning off the light can take a few seconds according to the connected motor.
3. Connecting and Disconnecting the Light Probe from the Motor
3-1 Connecting
1) Insert the light probe direct to the motor (Fig. 1). Screw the light probe until it clicks
and locks into position.
2) Confirm that the light probe is securely connected to the motor.
Light Probe Light Probe Motor Motor
3
Fig. 1