Switching Off The Alarm - Philips AJ 3936/17 Manual De Instrucciones

SETTING THE ALARM
Gentle wake volume
A sure way of getting up in the mornings, the gentle wake
volume for the alarm begins from zero volume (Lo:00) and
gradually increases to a high of 14 '
to change the default volume settings for the buzzer melody, radio
or CD alarm:
1. In the standby mode, press ALARM 1 or 2 MODE•OFF once.
2. As soon as Lo:00 appears, press UP7 or DOWN8 once or
more until you reach the desired level (0-32). This sets the
starting volume of your alarm.
3. To set the maximum volume for your alarm, press ALARM 1 or
2 MODE•OFF again to change to the '
4. As soon as ' ' appears, press UP7 or DOWN8 until you
reach the desired volume level (a number equal or greater than
the Lo, low setting).
Notes:
– The gentle wake volume settings do not affect normal CD and
radio playback volume level.
– It is not possible to check the gentle wake volume setting
during the active alarm call as pressing ALARM 1 or 2
MODE•OFF cancels the alarm completely.
– It is not possible to adjust the gentle wake volume during CD
playback mode.
16

SWITCHING OFF THE ALARM

'. If, however, you wish
' display.
X