Switching Off The Alarm - Philips AJ3010/04 Manual De Instrucciones

XP AJ3010/00 20-06-2000 16:33
Setting the alarm time and mode
1. Press ALARM SET for more than 2 seconds to enter alarm
time setting mode.
™ ALARM and the alarm time digits flash.
2. Press HR or MIN repeatedly or hold down on the button to
adjust the hours and minutes respectively. Release HR or
MIN when you reach the correct setting.
3. Press ALARM SET to confirm alarm time setting.
Notes:
– If you press TIME SET when setting the alarm time, the
display switches to the time setting mode.
– It is not possible to adjust the alarm time when the alarm
goes off, or when the repeat alarm mode is active.
4. To select the alarm mode you wish to be awoken by, set
the ALARM switch to RADIO or BUZZER ( m ) or ( k )
appears respectively.
• If you have selected the radio mode, make sure you have
adjusted the volume loud enough to wake you up!
™ The gentle wake buzzer alarm increases its beep tone
frequency within seconds.
Pagina 7

SWITCHING OFF THE ALARM

There are three ways of switching off the alarm. Unless you
cancel the alarm completely, the 24 hour alarm reset option
will be automatically selected after 59 minutes, from the time
your alarm time first goes off.
– 24 HOUR ALARM RESET
If you want the alarm mode to be stopped immediately but also
wish to retain the same alarm setting for the following day:
• Press ALARM RESET / RADIO OFF.
™ You will hear a beep tone confirming 24 hour reset
activation. The respective alarm indicator remains in
display.
– CANCELING THE ALARM COMPLETELY
To cancel the set alarm time before it goes off, or during the
alarm call:
• Set the ALARM switch to OFF.
™ The selected alarm indicator disappears from the display.
– REPEAT ALARM
This repeats your alarm call at 8 to 9 minute intervals.
7