Sub-Zero ICBUW-24 Guia De Instalacion página 12

MODEL ICBBW-30 INSTALLATION
Placement
CAUTION
Before moving the unit into position, secure the door
closed and protect any finished flooring.
Use an appliance dolly to move the unit near the opening.
If the unit has been on its back or side, it must stand upright
for a minimum of 24 hours before connecting power.
If the unit will be connected to a home security system, run
lead wires through the compressor compartment prior to
positioning the unit. Refer to page 13. Once the unit is in
position, wiring connection can be completed from the front.
Plug the power cord into the grounded (earthed) outlet, then
roll the unit into position. Verify the anti-tip brackets are
properly engaged.
IMPORTANT NOTE: If used, side panels will need to be
installed before the unit is placed in its final position.
12 | English
Alignment
LEVELING
Once the unit is in position, turn the front leveling legs
clockwise to adjust the height. The rear height adjustment
can be made from the front of the roller base. Using a
socket, turn the 3 / " hex bolt clockwise to raise the unit or
8
counterclockwise to lower. Use the lowest torque setting
when using a power drill. Do not turn the rear leveling legs
by hand. Refer to the illustration below.
When the unit is properly leveled, door adjustments are less
likely to be necessary.
Level the unit to the floor, not sur-
IMPORTANT NOTE:
rounding cabinetry. This could affect the operation of the
unit, such as door closing.
WARNING
To reduce the possibility of the unit tipping forward, the
front leveling legs must be in contact with the floor.
FRONT
LEVELING LEG
REAR
ADJUSTMENT
Leveling.
DOOR ADJUSTMENT
The door can be adjusted in and out, side to side tilt and up
and down.
3 / "
8
To make adjustments, slightly loosening the two upper hinge
bolts on the upper hinge plate using a 1
the illustration below.
In and out adjustment | For a left-hinge door, using a
allen wrench, turn the adjustment bolt clockwise to bring
the handle side of the door inward, and counterclockwise
to move the handle side outward. Reverse directions for a
right-hinge door.
Side to side tilt adjustment | For a left-hinge door, using a
3 / " wrench, turn the adjustment bolt clockwise to raise the
8
handle side of the door, and counterclockwise to lower the
handle side. Reverse directions for a right-hinge door.
Up and down adjustment | For a left-hinge door, using a
1 / " allen wrench, turn the adjustment bolt clockwise to raise
4
the door and counterclockwise to lower. Refer to the illustra-
tion below. Reverse directions for a right-hinge door.
UPPER
HINGE BOLTS
IN-AND-OUT
ADJUSTMENT
SIDE-TO-SIDE
TILT ADJUSTMENT
Door adjustment bolts. Up and down door adjustment.
Completion
GRILLE INSTALLATION
Install the grille assembly and check for proper fit. The grille
is designed to rest on the upper door hinge to minimize the
reveal between the top of the door and bottom of the grille.
To eliminate interference, the grille height can be adjusted.
/ " wrench. Refer to
2
Loosen the four grille adjustment screws (two on each side)
and adjust the grille height as needed. Refer to the illustra-
5 / "
tion below.
32
GRILLE
BACK GRILLE ADJUSTMENT
SCREW SCREWS
FRONT
GRILLE SCREW
Grille height adjustment.