Festo CPX-Terminal Instrucciones Para El Usuario página 9

1 User
The measuring module type CPX−CMIX−M1−1 is intended
exclusively for use in CPX terminals from Festo in
conjunction with suitable components. The maximum
values specified in the section Technical specifications"
must be observed here.
The CMIX makes available the position of the connected
displacement encoder/sensor interface in the CPX terminal
as an analogue value.
Detailed information on the CMIX measuring module can
be found in the manual on the CMIX type P.BE−CPX−CMIX−...
Basic information on the CPX terminal can be found in the
CPX System manual P.BE−CPX−SYS−...
Warning
· Switch off the power supply before connecting or
disconnecting plugs (otherwise this could lead to
functional damage).
· Use only power units which guarantee reliable
electrical isolation of the operating voltage as per
IEC/DIN EN 60204−1. Observe also the general
requirements for PELV power circuits as per IEC/DIN
EN 60204−1.
· Connect an earthing cable with sufficient
cross−sectional area to the connection on the CPX
terminal marked with the earth symbol.
· The CMIX contains electrostatically sensitive
components. Therefore, do not touch any
components. Observe the handling specifications for
electrostatically sensitive components.
Further informationen, documents and downloads:
è www.festo.com
Festo CPX−CMIX−M1−1 0906NH English
instructionsEnglish
9