To Drain Tank; Air Compressor Pump Intake And Exhaust Valves - Porter Cable C3151 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

To Drain Tank

1.
Set the On/Auto/Off lever to "OFF".
2.
Pull the regulator knob out and turn counterclockwise to set the outlet
pressure to zero.
3.
Remove the air tool or accessory.
4.
Pull ring on safety valve allowing air to bleed from the tank until tank
pressure is approximately 20 psi. Release safety valve ring.
5.
Drain water from air tank by opening drain valve (counter-clockwise) on
bottom of tank.
tank rupture.
6.
After the water has been drained, close the drain valve (clockwise). The air
compressor can now be stored.
NOTE: If drain valve is plugged, release all air pressure. The valve can then be
removed, cleaned, the reinstalled.
Air Filter Inspection and Replacement
to cool prior to servicing.
A dirty air filter will not allow the compressor pump to operate at full capacity.
Before you use the compressor pump, check the air filter to be sure it is clean
and in place.
If it is dirty, replace it with a new filter.
1.
Remove the air filter cover.
2.
Remove the air filter from filter cover.
3.
Place new air filter into filter cover. Refer to the "Repair Parts" for the
correct part number.
4.
Replace air filter cover and lock into place.

Air Compressor Pump Intake and Exhaust Valves

Once a year have a Trained Service Technician check the air compressor pump
intake and exhaust valves.
Water will condense in the air tank. If not drained, water
will corrode and weaken the air tank causing a risk of air
Hot surfaces. Risk of burn. Compressor heads are
exposed when filter cover is removed. Allow compressor
Keep the air filter clean at all times. Do not operate the air
compressor with the air filter removed.
17 - ENG
A16758

Publicidad

Tabla de contenido
loading

Tabla de contenido