Installation On The X-Lite Helmets; Preliminary Operations; Installing The System In The Helmet - Nolan N-Com B601 X Serie Manual Del Usuario

EN
4

INSTALLATION ON THE X-LITE HELMETS

This procedure must be followed for the installation of N-Com systems on X-lite helmets other than model X-
903.
Important: Prior to installing the N-Com system, it is recommended to write down the identification code
affixed to the product (see chapter 18.5).
The installation video can be seen at www.n-com.it / Support section.
4.1

Preliminary operations

 Remove the internal comfort padding by following the specific instructions provided in the helmet user
manual.
 If present, remove from the polystyrene cheek pads the foam filling material that cover the housings of the
N-Com earphones. Keep this filling materials should you decide in the future to use the helmet without the
N-Com system installed.
4.2

Installing the system in the helmet

 Connect the battery to the wiring system (Fig. 23).
 Position the battery in the right polystyrene cheek pad housing and secure it using the Velcro ribbon (Fig. 24).
 Position the right-hand side speaker in the specific cheek pad housing and secure it using the specific
adhesive (Fig. 25).
 Reposition the right polystyrene cheek pad in its housing.
ONLY FOR FULL-FACE HELMETS: Insert the chin strap into the polystyrene cheek pad loop.
Fig. 23
Fig. 26
10
Fig. 24
 Arrange the battery connector behind the polystyrene cheek pad.
 Arrange the cable behind the polystyrene shell or inside the relevant
housing (Fig. 26).
Fig. 25