Nolan N-Com B601 X Serie Manual Del Usuario página 11

Fig. 27
Fig. 28
 Remove the small N-Com cap positioned on the left side of the helmet. To make the operation easier, we
recommend pushing the cap from inside the helmet (Fig. 30).
 Thoroughly clean the outside surface of the shell to make sure that the adhesive keyboard sticks properly.
Before you apply the keyboard, make sure that the shell area is completely clean and grease or dirt free.
 Remove the protective film from the back of the adhesive keyboard using the special tab (Fig. 31).
 Pass the keypad flex through the hole in the outer shell (Fig. 32).
Fig. 30
Fig. 33
Note: Make sure you do not glue the keypad flex underneath the keypad support.
Note: In the event that the keyboard is not positioned correctly, peel it off right away with extreme care and
repeat the positioning.
ONLY FOR X-702 HELMET:
 Position the battery connector and wiring underneath the shell
gasket (Fig. 27).
 Cut along the pre-cut lines of the plastic tab on the back of the
comfort padding (Fig. 28).
 Secure the wiring underneath the plastic tab. Close the cut parts
using the cable fixing adhesives (Fig. 29).
Fig. 29
Fig. 31
 Apply the keyboard to the shell and press down on its entire surface to
make sure that it sticks properly (Fig. 33).
Fig. 32
11