Microphone Positioning - Nolan N-Com B601 X Serie Manual Del Usuario

EN
Note: It takes up to 24 hours for the keyboard to stick completely. During this time, do not expose the helmet
to atmospheric agents.
 Line up the keypad flex connector to the e-box making sure that the letter "n" is pointing as shown in Fig. 34.
 Gently position the connector in its seat until it is all the way in (Fig. 35).
 Switch on the N-Com system (press "ON" for about 2 seconds) to verity its proper operation.
N.B. If the system does not work, remove the flex and repeat the previous operation, making sure that the "n"
is positioned as in Fig. 34.
Fig. 34
 Secure the keypad flex in the special stop (Fig. 36) and position the e-box inside its housing in the cheek pad
(Fig. 37).
 Temporarily reposition the polystyrene cheek pad inside the helmet and continue with the subsequent
paragraph.
Fig. 36
4.3

Microphone positioning

JET HELMETS
 Insert the microphone securing clip. Note: The flat part of the clip has to face upward when the microphone is
positioned as shown in Fig. 38.
 Position the microphone on the left side of the helmet, screwing in the screw in the small shell frame (Fig. 39),
being careful that the side of the microphone support with the letter "n" is facing towards the inside of the
helmet (Fig. 40).
Fig. 38
12
Fig. 35
Fig. 37
Fig. 39
Fig. 40