RAMSEY WINCH RPH-20,000 Manual De Funcionamiento, Reparación Y Mantenimiento página 9

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6. Remove output coupling (item #7) and coupling shaft (item #6) from end bearing (item
#9). Examine bearings (item #13), pressed in output coupling (item #7), for signs of
wear. Replace bearings, if necessary, by pressing old bearings from coupling and press
new bearings (item #13) into each end of output coupling (item #7). Place coupling
shaft (item #6) into bearings (item #13).
7. Remove (8) capscrews (item #15) to pull gear-housing cover from ring
. Remove input thrust washer, sun gear, carrier assemblies, and
gear
spacer (item #13) from inside of ring gear. Examine splines of ring gear
and if necessary, remove ring gear from end bearing (item #9) by
removing (12) capscrews (item #16). Examine bushing (item #14) for
signs of wear. Replace bushing, if necessary, by pressing old bushing
from housing and pressing new bushing into place.
Apply RTV sealing compound to ring gear-mounting surface of end bearing
(item #9). Place ring gear onto end bearing, aligning holes in ring gear with
holes and gear housing end bearing. Secure ring gear to end bearing using
(12) capscrews (item #16). Torque to 40 ft-lbs, each in a criss-cross pattern.
Examine shifter shaft (item #12) for signs of wear, replace if necessary.
8. NOTE: DETERMINE MOUNTING CONFIG-
URATION
OF
WINCH
MOUNTED) BEFORE ATTACHING FRONT
AND REAR FRAME ASSEMBLY TO WINCH,
TO ASSURE PARTS ARE MOUNTED TO
PROPER
SIDE,
REFER
MOUNTING CONFIGURATIONS, PAGE 6.
Seat well-oiled quad-rings (item #38 &
#39) into groove of bushing in each end of
drum assembly (item #2), as shown.
Carefully set drum assembly (item #2)
down over motor end bearing (item #9). Lift
gear-housing end bearing (item #9) and set
into place on drum assembly. Install frame
assembly (item #1) using capscrews and
lockwashers shown below.
capscrews securely, check rotation of cable
drum.
(R.H.
or
L.H.
TO
WINCH
16
25
Tighten (4)
GEAR HOUSING
COVER
39
8
17 25
1
16 25
9
6
14
7
14
9
21
RING GEAR
13
12
15
9
22
22
2
40
17 25
9
RING GEAR

Publicidad

Tabla de contenido
loading

Tabla de contenido