Harbor Breeze 40190 Manual De Instrucciones página 11

STANDARD OR ANGLE MOUNTING INSTRUCTIONS
5 . If you decided to cut back the lead wire in Step 4,
strip 1/2 in . of insulation from the end of the white
wire . Twist the stripped ends of each strand of wire
within the insulation with pliers (not included) . Repeat
the step for black and green wires .
Note:
If you did not cut back the lead wires in Step
4, Step 5 is not necessary and you may proceed to
Step 6 instead .
6 . Install the ball end of the downrod (A) into the opening
of the mounting bracket (C) . Align the slot in the ball
with the tab in the mounting bracket (C) . Note: The rod
should not rotate if it is done correctly .
DANGER: Failure to align the slot in the ball
with the tab may result in serious injury or death .
Proceed to the Wioiag on page 13 .
5
6
11
A
Lowes.com/harborbreeze
C